waterfalls

JJJ · Post by **JJJ** » Fri Jan 06, 2006 3:27 am

Not sure if I got the right forum, but I couldn't find one for builders. Sorry if it's wrong.

I'm building a river in an area, and I want it to go down hill ... water does that, gravity being what it is.

So, I have two levels, one raised above the other. I can't get the 'Rural stream' to go up to the edge, so the river stops, there's grass and a cliff, and then some more river. What should I do?

I fairly sure the problem can be solved cos I've seen plenty of sweet waterfalls.

Tileset is CFR C/G Shrunk, btw

Cheers,
mat

Czarcasm · Post by **Czarcasm** » Fri Jan 06, 2006 3:42 am

Place another rural stream on the tile above the one where it ends, too (Just keep drawing a line of stream through the cliff). That'll give you a waterfall.

JJJ · Post by **JJJ** » Fri Jan 06, 2006 3:48 am

Heh, it worked. Thought I'd tried that already (I did, honest I did I did I did) and it came up red!

Cheers, thanks for the superquick response!